|
Grizzly G1026 3 HP Shaper | 
 enlarge
| Brand: Grizzly
Category: Home Improvement
Buy New: $895.00
Rating:  3 reviews
Sales Rank: 32943
Media: Misc.
Dimensions (in): 0.3 x 0.3 x 0.4
MPN: G1026
UPC: 690550010262
EAN: 0690550010262
ASIN: B0000DD0B4
Availability: Usually ships in 1-2 business days
| |
| Features:
| • | 2 spindle speeds: 7,000 and 10,000 R.P.M. | | • | 3 H.P., single phase, 220V motor with reversing switch | | • | 3 interchangeable spindles: 1/2", 3/4" and 1" | | • | Spindle travel is 3" | | • | Table with standard wing attached measures 30-1/2" x 28-1/4" |
|
| Accessories:
|
| Similar Items:
|
| Editorial Reviews:
Product Description
STANDARD EQUIPMENT INCLUDES: Motor, reversing switch, magnetic power switch, miter gauge and fence with hold-down springs.
|
| Customer Reviews:
Wright Cabinets September 2, 2006
S. Wright (Nacogdoches, TX)
10 out of 10 found this review helpful
Useful machine - we have 2 in the shop and they work well in tandem doing production rails and stiles for doors, windows and cabinet ends. Not sure that they are up to the job of working all day on the raised panels that we do but then we also have a 5hp beast that does that with a power feeder. All in all, a good buy for the dollar and I would rather buy three of these rather than one of 3 combo machines that Grizzly make. Better than the Delta and not nearly as expensive as the Powermatic...
Just got my shaper and so far so good! March 5, 2006
Rand T. Frantz (California)
14 out of 15 found this review helpful
Price can't be beat. Only drawback (so far) is the clean up of the grease and oil. Have a lot of rags and some kind of degreaser ready. They cover the bare metal with a grease/wax of some sort and put all kinds of oil in the small parts bags. On the up side, I didn't notice any rust and that's the whole idea. I was expecting much less than I got with this shaper. It has a nice fence, good fit and finish and solid running motor. There is no dust collection port on the fence, however. So, it is necessary to fabricate one to attach to the rear. I am skeptical about how well that will work though. The cutter area has many openings where chips can fly and even with rear dust collection chips will find their way out, I believe. All in all, I feel I got a good machine.
Good, but needed a fix February 16, 2006
Starting over in New Orleans (Louisiana)
15 out of 15 found this review helpful
This shaper is a solid value and works well, however, while I was assembling the shaper I noticed the fence was out of line by about an 1/8 of an inch. Manual says to shim the fence boards, but don't bother. Instead take a closer look at the screw holes in the housing cover where it attaches to the table top. One of the holes was clearly not where the other one was. After spending time elongating the hole, I could finally get the two fences to line up. Other than that, no problems. Also, comes with a cast iron hand wheel instead of the plastic one whown in the photos.
|
|
|
Copyright 2008 | |
